Product Alert: Dillon XL750 Powder Measure and Mini Mr.BulletFeeder Compatibility
Important Information: Please be aware of the following compatibility considerations for the Dillon XL750 Powder Measure and the Mini Mr.BulletFeeder by DAA:
-
Dillon XL750 Powder Measure:
-
The powder measure on the Dillon XL750 is angled and cannot be repositioned.
-
The powder bar must extend directly over station #4 in the toolhead.
-
This can create an issue if you intend to run a powder check in station #3 and a bullet dropper in station #4.
-
Extra-Short Dillon Powder Bar:
-
To address the above issue, we offer the Extra-Short Dillon Powder Bar as a solution.
-
This allows for more flexibility in positioning components in stations #3 and #4.
-
Mini Mr.BulletFeeder by DAA:
-
Uses a 6-tube magazine system, holding approximately 100 bullets.
-
Feeds into the reliable dropper die assembly used on the Mr.BulletFeeder.
-
Requires manual filling of bullet tubes before reloading, offering a cost-effective alternative.
-
Can be used on any progressive reloading machine using Dillon-compatible dies.
-
Compatibility note: The powder funnel supplied is designed for use only in the Dillon powder drop.
-
Compatibility Considerations:
-
Ensure that your reloading machine has a station in the tool head directly after the powder dropper for the bullet feeder.
-
For Dillon XL750 users, using a powder check in the following station may pose challenges due to the angle of the powder dropper.
Included in the Mini Mr.BulletFeeder Package:
-
1 x 6-Tube Bullet Magazine Assembly
-
1 x Dropper Die Assembly
-
1 x Expanding powder funnel (Dillon compatible)
-
3 x Spare Steel Ball-Bearings for Dropper
-
1 x User Instruction Sheet
Make sure to consider these compatibility factors to optimize the performance of your Dillon XL750 and Mini Mr.BulletFeeder combination. If you encounter challenges, the Extra-Short Dillon Powder Bar is available as a solution.