Lee Bullet Sizing Kits are the fastest and easiest way to size cast bullets. Standard 7-8x14" threads fit any single stage reloading press. Bullets are pushed through the sizing die nose first, so no special nose punches are needed. Gas checks are automatically seated and crimped in place. Sized bullets are captured in the special container. Complete for one size. Press and bullet lubricant are sold separately. Special note: Intended for use on single stage presses only. The push through Punch is used in place of a Shell Holder in the Ram. Lee does not make top punches for molds. With the use of this kit, a top punch is not necessary. To crimp gas checks with the lube and size kit, first lubricate the bullets with liquid alox, push a gas check on the base of the bullet and set the bullet on the punch. When the bullet is pushed through the sizing die, the bullet will be sized, and the gas check will be crimped on. For cast bullets, you want to select a sizing kit to be .001" larger than groove diameter.
Die Lee Bullet Sizing Kits sind die schnellste und einfachste Möglichkeit, gegossene Geschosse zu sizing. Die Standard 7-8x14" Gewinde passen auf jede Einzellader-Wiederladepresse. Die Geschosse werden mit der Spitze zuerst durch die Sizing-Düse geschoben, sodass keine speziellen Spitzenstempel benötigt werden. Gaschecks werden automatisch eingesetzt und an Ort und Stelle gecrimpt. Die sized Geschosse werden in dem speziellen Behälter aufgefangen. Komplett für eine Größe. Presse und Geschoss-Schmiermittel sind separat erhältlich. Besondere Anmerkung: Nur für die Verwendung auf Einzelladerpressen vorgesehen. Der Durchschlag wird anstelle eines Shell Holders im Ram verwendet. Lee stellt keine Top Punches für Formen her. Mit der Verwendung dieses Kits ist ein Top Punch nicht notwendig. Um Gaschecks mit dem Lube und Size Kit zu crimpen, fette zuerst die Geschosse mit flüssigem Alox, drücke einen Gascheck auf die Basis des Geschosses und setze das Geschoss auf den Durchschlag. Wenn das Geschoss durch die Sizing-Düse geschoben wird, wird es gegrößert und der Gascheck wird angecrimpt. Für gegossene Geschosse solltest du ein Sizing-Kit wählen, das .001" größer ist als der Zughalsdurchmesser.