ICARUS BLAST DIFFUSER The Icarus is a blast diffuser designed to work with all Rearden muzzle devices. This blast diffuser will assist in sending blast and concussion down range, as well as serve as a thread protector for your muzzle devices when shooting unsuppressed. This is not a flash hider, and has no flash hiding capabilities. FEATURES: 17-4 PH Compatible with all Rearden muzzle devices, as well as any other Plan B style muzzle device. Nitride OR PVD coating No Atlas needed Weight and Length: Weight: 4.5 oz Length: 3.3″ For use with projectiles .355 (9mm) and less in diameter INSTALLATION These blast diffusers fit over plan B style muzzle devices. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the blast diffuser on the muzzle device, ensure that the threads and tapers are clean. Do not exceeed 10 ft lbs of torque on the Icarus. Ensure alignment. Enjoy. *End cap is removeable, but will come Rockset out of the box.
ICARUS BLAST DIFFUSER Der Icarus ist ein Blast Diffuser, der für alle Rearden Mündungsgeräte entwickelt wurde. Dieser Blast Diffuser hilft dabei, den Blast und die Druckwelle nach vorne zu leiten und dient zudem als Gewindeschutz für deine Mündungsgeräte beim Schießen ohne Schalldämpfer. Dies ist kein Flash Hider und hat keine Fähigkeit, Lichtblitze zu verbergen. EIGENSCHAFTEN: 17-4 PH Kompatibel mit allen Rearden Mündungsgeräten sowie jedem anderen Plan B Mündungsgerät. Nitride ODER PVD-Beschichtung Kein Atlas erforderlich Gewicht und Länge: Gewicht: 4,5 oz Länge: 3,3″ Für die Verwendung mit Projektilen von .355 (9mm) und kleiner im Durchmesser INSTALLATION Diese Blast Diffuser passen über Plan B Mündungsgeräte. Verwende immer eine Ausrichtungsstange, um sicherzustellen, dass das gesamte System korrekt eingerichtet ist. Stelle sicher, dass alle Oberflächen gereinigt sind und das Mündungsgerät fest und mit Rockset am Lauf montiert wurde. Ziehe das Mündungsgerät auf etwa 30 ft lbs an. Achte darauf, dass das Mündungsgerät rechtwinklig zur Schulter steht. Wenn du den Blast Diffuser auf das Mündungsgerät setzt, stelle sicher, dass die Gewinde und Konen sauber sind. Überschreite nicht 10 ft lbs Drehmoment auf dem Icarus. Achte auf die Ausrichtung. Viel Spaß. *Der Endkappen ist abnehmbar, kommt jedoch mit Rockset aus der Verpackung.