The Sinclair Bullet Comparator inserts are meant to be used with the Sinclair Bullet Comparator and Bump Gage Body. These inserts are stainless steel and machined with a taper and a short straight section to more accurately duplicate the chamber throat. This eliminates the wobble experienced with many comparators which have standard drilled holes. Our design allows you to quickly and accurately measure and compare bullet ogive-to-base as well as loaded round ogive-to-cartridge-base measurements. This measurement gives more consistent results than measuring overall lengths since the meplat (the open tip of the bullet) can very by several thousandths of an inch from bullet to bullet.
Die Sinclair Bullet Comparator Einsätze sind dafür gedacht, mit dem Sinclair Bullet Comparator und dem Bump Gage Body verwendet zu werden. Diese Einsätze bestehen aus rostfreiem Stahl und sind mit einem Konus und einem kurzen geraden Abschnitt gefertigt, um die Kammerhalsform genauer zu reproduzieren. Dadurch wird das Wackeln vermieden, das bei vielen Comparators mit standardmäßig gebohrten Löchern auftritt. Unser Design ermöglicht es dir, schnell und präzise die Messungen von Bullet Ogive-to-Base sowie geladenen Rund-Ogive-to-Cartridge-Base zu messen und zu vergleichen. Diese Messung liefert konsistentere Ergebnisse als die Messung der Gesamtlängen, da die Meplat (die offene Spitze der Patrone) von Bullet zu Bullet um mehrere Tausendstel Zoll variieren kann.