Ihr Warenkorb ist leer.

Warenkorb

Hilfe und Kontakt

Versand innerhalb Deutschlands: 2€

100-tägiges Rückgaberecht

Newsletter

Angebote

Über 300.000 Kunden - wir sagen Danke!

4,93/5 "Sehr gut" (1400+ Bewertungen)

40,000+ Produkte aus Jagd und Schiesssport

TPS PRODUCTS
TPS PRODUCTS, LLC. TSR PICATINNY SCOPE RINGS

071611305815 100000958

Super Holding Power, Precision Alignment

TSR Series Rings, precisely machined from an aluminum billet, with tolerances held to .0002", give maximum scope/ring contact. Holds scope securely against recoil. Four-screw cap lets you align the reticle, tighten the left side of the cap, then the right side without the scope rotating. Radiused edges and corners help prevent snagging while providing attractive appearance. Large, clamp-nut lets you torque rings to Mil-STD 1913 (Picatinny) bases.

SPECS: 7075-T651 Aluminum Alloy, matte black, hard anodized to Mil-A-8625 standards. 5/8" (15.8mm) wide. Height measured from top of base to center of ring. 30mm - High: 1.225" (31.1mm).

Mehr...

Super Haltekraft, präzise Ausrichtung

Die TSR-Serie Ringe, präzise aus einem Aluminiumblock gefräst, mit Toleranzen von .0002", bieten maximalen Kontakt zwischen Zielfernrohr und Ring. Hält das Zielfernrohr sicher gegen Rückstoß. Der Vier-Schrauben-Kappen ermöglicht es dir, das Fadenkreuz auszurichten, die linke Seite der Kappe festzuziehen und dann die rechte Seite, ohne dass sich das Zielfernrohr dreht. Abgerundete Kanten und Ecken helfen, ein Hängenbleiben zu verhindern und sorgen für ein ansprechendes Aussehen. Große Klemmmutter ermöglicht es dir, die Ringe an Mil-STD 1913 (Picatinny) Basen zu torquen.

SPECS: 7075-T651 Aluminiumlegierung, matt schwarz, hart eloxiert nach Mil-A-8625 Standards. 5/8" (15,8mm) breit. Höhe gemessen von der Oberseite der Basis bis zur Mitte des Rings. 30mm - Hoch: 1.225" (31,1mm).

Mehr...

Kundenbewertungen zu TPS PRODUCTS, LLC. 30mm Medium (1.075") Aluminum Rings

Anzahl der Bewertungen: 25
Von brownells.com: 25
Durchschnittliche Bewertung: 4,6

Great Rings (16.04.2010)

Mounted these rings on a brand new Savage model 12FCV 22-250 and I couldn't be happier. They were recomended by a gunsmith buddy and he was right. No lapping required. Didn't have to adjust the scope much at all to get it sighted in because it was aligned so well. Don't waste your money on the big name rings and basis. Save that for the glass and rifle.

Great value, but not tall enough for AR (11.05.2011)

The quality of these rings is excellent. Great value here. These are very comparable to Leupold tactical rings at a much lower price. I got these for a flat top AR varmint rig to mount my VX3 4.5-14 X 50 30mm Long Range. These rings are rock solid. Gun spends everyday bouncing in feedtruck, but stays spot-on. These rings ARE NOT tall enough for this set-up. Just wish they came 1/4 in. taller. In the proper set-up, you'll be very satisfied. Five star item, but need to specify on a "tactical style" ring set that they will NOT work on an AR.

Height seems fine (20.03.2012)

Not sure what to add to the other reviews. Put this on a AR platform built in .450 with a Leupold 30mm scope. The "high" size lines up just right for me with a Rock River Arms stock. They seem to be holding just fine and the guns shoots 1" at 100.

Solid performer (18.09.2012)

This is my second set of these aluminum tactical rings from TPS. They are very solidly built, easily installed and perfectly square. I set up AR's for tactical competition, these rings have been perfect. Have had no problems with removing scope and remounting, holding point of aim every time. I would recommend these stout well built rings as best value.

Great rings (28.11.2011)

For the money these are the best rings you can get. I have them on three of my bolt guns and one of my AR-15's. TPS mounts are great too.

Best value rings I have used (06.03.2012)

These were recommended by a friend and he was correct. Excellent value for money.

Better than the rest (08.01.2010)

These are top of the line rings, they are better due to their quality control. There is no need to lap them like with badger. and the price is half of what you'd pay for .

Outstanding Quality (16.03.2015)

I highly recommend these rings.

The quality is equal to another set that I paid twice as much for. They are very solid, have an excellent finish, and mounted perfectly. I am very happy with them.

Excellent Rings (23.11.2009)

This is my second set of TPS/TSR rings. They come with detailed instructions. The finish and quality are very good. The high rings worked great for me mounted on an AR-15.

Great product (12.12.2009)

High quality, rugged, and good looking.

Best rings for the money (08.01.2010)

These have got to be the best rings for the money. I have 3 different sets of these along with several sets of Leupold Mark 4 rings. They are just as sturdy and well built at the Leupolds. I am very impressed with them and recommend them to all.

Exceptional (17.12.2010)

These rings allowed me to mount a 50mm scope on a PRI "tube". The threaded portion of the shaft allows for positive mounting. The instructions are very detailed and should be followed.

A Great Value In A Tactical Ring (21.06.2009)

These rings are precisely machined and have an excellent, uniform finish. The upper and lower ring components are indexed during installation and allow for slight variations in scope diameters. The torx ring screws and picatinny mounting bolt are rock solid and stay put under recoil. If you are looking for a high quality aluminum tactical ring, the TSR is a great value.

Excellent Robust Rings (30.08.2010)

I have four pairs of these rings. They are very well machined and very well finished. I used the alignment and lapping tools on my installations, but I could have easily skipped this step without any issues as no excess material was removed. Alignment has been perfect and grip on the scope tubes is excellent as well. I have switched scopes multiple times and have not had any issues with ring marks on the scope tubes, unlike other steel rings with poor alignment.

Awesome Rings! (27.10.2010)

I put the rings on an AR I hunt with and target shoot at 300-800 yds with. I was very impressed with the fit and finish on these rings. I lapped them in and it was the most even lapping job I have done, which is a testament to their machining. So far I have been very pleased.

Good Craftsmanship, but... (26.12.2011)

The quality and finish are excellent, with no tooling marks. I had a lot of difficulty adjusting the horizontal cant of my scope when following the included instructions. I tried to snug down one side and make adjustments from there, but only after I stopped using TSP's advice could I make it work. Very high quality product, instructions could be better.

Excellent rings (04.02.2013)

Very fine quality

easy rings to install (29.04.2014)

Used on a new AR-15 and getting the scope not to tilt, when tightening the screws, after getting it straight was as simple as 123.
Will be using them again and again and again!

Great Rings (28.06.2016)

Very nice rings. High quality at a good price. I lapped these rings, but after a strokes I could tell they didn't need to be lapped. I own two sets of the TPS rings. Think I need more.

Great picatinny aluminum rings! (23.05.2010)

Much better quality than a set of Burris XTR tactical rings I have. Good price, well made, look good. I used them to mount a scope with an EGW picatinny rail on a new Winchester M70 Coyote Light.

Great Rings! (21.01.2011)

Well made, good finish

Junk (13.02.2012)

My rings fell apart after 37 rounds. The claw on the bottom of the mount sheared off and TPS was completely unwilling to help.

Broke during installation. (06.03.2016)

While mounting the base to the rifle with a torque wrench set at 15 lbs, the base snapped.

Never had any problems (10.06.2017)

I've purchased several sizes in aluminum w/o any problems . Maybe the previous reviewer should read up on torque specs before bashing !!!! Tighten to 15 lbs ?????? Hello proper torque is in inch/pounds !!! I usually go by the scope manufacturers recommendations. Usually between 18-25 inch/pounds . Every set I purchased are top quality ,well machined and provide rock solid mounting .I won't hesitate to buy another set of TPS aluminum rings .

Excellent 1" scope rings (20.11.2017)

These high quality rings are a good value and perform well. Have used them on five rifles and they have worked perfectly so far. They come with clear instructions and are designed to be installed on Weaver or picatinny type rails and torqued to 65 in./lbs. - NOT ft./lbs...

The ring screws are designed to be torqued to 15 in./lbs. Read and follow the instructions and they will serve you well.

Lesen Sie 25 weitere Bewertungen bei brownells.com

204.9 204.9 23 EUR

Artikel-Nr.: 100000958
TPS PRODUCTS, LLC. 30mm Medium (1.075") Aluminum Rings
Herstellerproduktnummer: 30581 071611305815 Die TSR-Serie Ringe, präzise aus einem Aluminiumblock gefräst, mit Toleranzen von .0002", bieten maximalen Kontakt zwischen Zielfernrohr und Ring. Hält das Zielfernrohr sicher gegen Rückstoß. Der Vier-Schrauben-Kappen ermöglicht es dir, das Fadenkreuz auszurichten, die linke Seite der Kappe festzuziehen und dann die rechte Seite, ohne dass sich das Zielfernrohr dreht. Abgerundete Kanten und Ecken helfen, ein Hängenbleiben zu verhindern und sorgen für ein ansprechendes Aussehen. Große Klemmmutter ermöglicht es dir, die Ringe an Mil-STD 1913 (Picatinny) Basen zu torquen.

Benachrichtigt werden, sobald verfügbar? Hier klicken

Nicht verfügbar.

Eigenschaften: Art: Tactical Rings Finish: Matte Blue Größe: Medium Höhe: 1.075'' Material: Aluminum Rohrdurchmesser des Zielfernrohres: 30mm

TPS PRODUCTS TPS PRODUCTS, LLC. TSR PICATINNY SCOPE RINGS

Kundenbewertungen zu TPS PRODUCTS, LLC. 30mm Medium (1.075") Aluminum Rings

Top Takeaways

Eigenschaften

Artikeldetails

Kundenbewertungen zu TPS PRODUCTS, LLC. 30mm Medium (1.075") Aluminum Rings

Vernetzen

Sichere Bezahlmethoden

Berufsverbände

Willkommen!

TPS PRODUCTS
TPS PRODUCTS, LLC. TSR PICATINNY SCOPE RINGS